Fuzzy Floor
Cage Level
Habitat Extender
Parts and Installation
The Fuzzy Floor Cage Level for the Midwest Playpen
consists of:
One (1) Fuzzy Floor Cage Level
Two (2) long dowels for the front and back of the cage*
Two (2) short dowels for the cage sides*
? One packet containing 4 short dowels to aid in installation
* The Basement model has double the amount of dowels
The Fuzzy Floor Cage Level may be installed at any height,
although the level at which the doors hinge will interfere with opening the door.
The system may be installed through the door openings without affecting the operation or security of the door.
Simply thread the dowel through the loops at the door opening until the dowel meets up with the cage bars again. (See Picture)
|
|
Fuzzy Floor Cage Level Patent Pending
|
The loops fit through the vertical cage bars, extending to the outside of the cage where the acrylic dowels are inserted to
secure the floor to the cage. (See above Picture)
For easy installation, temporarily secure your Fuzzy Floor to the cage at all 4 corners by using the 4 short installation
dowels provided.
* Basement model installation-start with lower set of web loops
Begin by putting the Fuzzy Floor inside the cage. Insert a short dowel in the end loop on the long side. At the desired
height, turn the dowel vertically so it will go through the cage bars in the second space from the corner. Turn dowel back horizontal so it locks in place
against the cage bars. (See Picture 2)
(Pic 2)
The permanent dowel for the back may now be installed from the outside of the cage. Using one of the long dowels,
push the short temporary dowel through the securing loop at either end and continue across until the long dowel is threaded through all the loops on
that side.
Repeat this process for the sides and finish with the front.
Note: The first loop on the side belongs in the first cage bar space.
|